§ 1607.14 Technical standards for validity studies.

The following minimum standards, as applicable, should be met in conducting a validity study. Nothing in these guidelines is intended to preclude the development and use of other professionally acceptable techniques with respect to validation of selection procedures. Where it is not technically feasible for a user to conduct a validity study, the user has the obligation otherwise to comply with these guidelines. See sections 6 and 7 above.

A. Validity studies should be based on review of information about the job. Any validity study should be based upon a review of information about the job for which the selection procedure is to be used. The review should include a job analysis except as provided in section 14B(3) below with respect to criterion-related validity. Any method of job analysis may be used if it provides the information required for the specific validation strategy used.

B. Technical standards for criterion-related validity studies—(1) Technical feasibility. Users choosing to validate a selection procedure by a criterion-related validity strategy should determine whether it is technically feasible (as defined in section 16) to conduct such a study in the particular employment context. The determination of the number of persons necessary to permit the conduct of a meaningful criterion-related study should be made by the user on the basis of all relevant information concerning the selection procedure, the potential sample and the employment situation. Where appropriate, jobs with substantially the same major work behaviors may be grouped together for validity studies, in order to obtain an adequate sample. These guidelines do not require a user to hire or promote persons for the purpose of making it possible to conduct a criterion-related study.

(2) Analysis of the job. There should be a review of job information to determine measures of work behavior(s) or performance that are relevant to the job or group of jobs in question. These measures or criteria are relevant to the extent that they represent critical or important job duties, work behaviors or work outcomes as developed from the review of job information. The possibility of bias should be considered both in selection of the criterion measures and their application. In view of the possibility of bias in subjective evaluations, supervisory rating techniques and instructions to raters should be carefully developed. All criterion measures and the methods for gathering data need to be examined for freedom from factors which would unfairly alter scores of members of any group. The relevance of criteria and their freedom from bias are of particular concern when there are significant differences in measures of job performance for different groups.

(3) Criterion measures. Proper safeguards should be taken to insure that scores on selection procedures do not enter into any judgments of employee adequacy that are to be used as criterion measures. Whatever criteria are used should represent important or critical work behavior(s) or work outcomes. Certain criteria may be used without a full job analysis if the user can show the importance of the criteria to the particular employment context. These criteria include but are not limited to production rate, error rate, tardiness, absenteeism, and length of service. A standardized rating of overall work performance may be used where a study of the job shows that it is an appropriate criterion. Where performance in training is used as a criterion, success in training should be properly measured and the relevance of the training should be shown either through a comparsion of the content of the training program with the critical or important work behavior(s) of the job(s), or through a demonstration of the relationship between measures of performance in training and measures of job performance. Measures of relative success in training include but are not limited to instructor evaluations, performance samples, or tests. Criterion measures consisting of paper and pencil tests will be closely reviewed for job relevance.

(4) Representativeness of the sample. Whether the study is predictive or concurrent, the sample subjects should insofar as feasible be representative of the candidates normally available in the relevant labor market for the job or group of jobs in question, and should insofar as feasible include the races, sexes, and ethnic groups normally available in the relevant job market. In determining the representativeness of the sample in a concurrent validity study, the user should take into account the extent to which the specific knowledges or skills which are the primary focus of the test are those which employees learn on the job.

Where samples are combined or compared, attention should be given to see that such samples are comparable in terms of the actual job they perform, the length of time on the job where time on the job is likely to affect performance, and other relevant factors likely to affect validity differences; or that these factors are included in the design of the study and their effects identified.