View Source

40 C.F.R. § 63.1429

Process vent monitoring requirements.

§ 63.1429 Process vent monitoring requirements.

(a) Monitoring equipment requirements. The owner or operator of a process vent that uses a combustion, recovery, or recapture device to comply with the process vent control requirements in § 63.1425(b)(1), (b)(2), (c)(1), (c)(3), or (d) shall install monitoring equipment specified in paragraph (a)(1), (2), (3), (4), (5), (6), or (7) of this section, depending on the type of device used. Also, the owner or operator that uses a recovery or recapture device to comply with § 63.1425(c)(4) shall install monitoring equipment as specified in paragraph (a)(4), (5), (6), or (7) of this section. All monitoring equipment shall be installed, calibrated, maintained, and operated according to manufacturers' specifications or other written procedures that provide adequate assurance that the equipment would reasonably be expected to monitor accurately.

(1) Where an incinerator is used, a temperature monitoring device equipped with a continuous recorder is required.

(i) Where an incinerator other than a catalytic incinerator is used, a temperature monitoring device shall be installed in the firebox or in the ductwork immediately downstream of the firebox in a position before any substantial heat exchange occurs.

(ii) Where a catalytic incinerator is used, temperature monitoring devices shall be installed in the gas stream immediately before and after the catalyst bed.

(2) Where a flare is used, the following monitoring equipment is required: a device (including but not limited to a thermocouple, ultra-violet beam sensor, or infrared sensor) capable of continuously detecting the presence of a pilot flame.

(3) Where a boiler or process heater of less than 44 megawatts design heat input capacity is used, the following monitoring equipment is required: a temperature monitoring device in the firebox equipped with a continuous recorder. Any boiler or process heater in which all process vent streams are introduced with primary fuel or are used as the primary fuel is exempt from this requirement.

This document is only available to subscribers. Please log in or purchase access.
Purchase Login

About SCCE

The Society of Corporate Compliance and Ethics (SCCE) is a non-profit, member-based professional association. SCCE supports our members' work with education, news, and discussion forums. We are a community of leaders, defining and shaping the corporate compliance environment across a wide range of industries and geographic regions. In developing and maintaining effective ethics and compliance programs, our members strengthen and protect their companies.

952.933.4977

About HCCA

The Health Care Compliance Association (HCCA), is a 501(c)6 non-profit, member-based professional association. HCCA was established in 1996 and is headquartered in Minneapolis, MN. We provide training, certification, and other resources to over 10,000 members. Our members include compliance officers and staff from a wide range of organizations, including hospitals, research facilities, clinics and technology service providers.

952.988.0141

Facebook Twitter LinkedIn
Copyright © 2024 by Society of Corporate Compliance and Ethics (SCCE) & Health Care Compliance Association (HCCA). No claim to original US Government works. All rights reserved. All information provided through this site, including without limitation all information such as the “look and feel” of the site, data files, graphics, text, photographs, drawings, logos, images, sounds, music, video or audio files on this site, is owned and/or licensed by SCCE & HCCA or its suppliers and is subject to United States and international copyright, trademark and other intellectual property laws. Any third party logos and/or content provided herein is owned by such third parties and is used by permission herein. Your use of this site to is subject to our Terms Of Use and Privacy Statement.
Cookie settings